If the clock hands are touching that may be the reason the clock stopped moving.
Wall clock hands not working.
To maintain a battery powered quartz wall clock make sure to replace the battery and reduce friction when needed.
Push the hour hand back and forth gently to release it.
You can likely replace the actual clock itself keeping the frame faceplate and hands.
Bend the hour or minute hand whichever is on top slightly toward you to create clearance.
Make sure the clock hands are properly seated on the clock shaft and not catching on each other.
The hour hand is held to the shaft via friction.
Friction holds the hour hand on the shaft and.
When battery operated clocks stop working it s usually caused by one or more of the batteries.
If it s simply a matter of tightening the hands push the hour hand against the clock shaft first.
Push the hour hand against the clock shaft.
This problem is usually caused by set.
A replacement should run you a few dollars.
A small push can give it the connection it needs to get back in time with the second hand.
This is usually either because the clock is.
If the hands on your clock refuse to remain tight you may need to replace the nut or the clock hands.
Hold the second hand and tighten the tiny nut at the end of the shaft with needle nose pliers.
In two minutes artist and clockmaker pamela corwin shows you how to address a wall clock with non moving hands.
Cheap clocks usually just have a generic plastic clock attached to the back.
The hands aren t moving.
If you have a bike chain desk clock 26f try re seating the battery.
In other words take the battery out and put it back in making sure it is nicely seated.
Often the internal mechanisms such as the cogs springs and other movements of the clock are not faulty and are unaffected.
If your clock stops working open the battery compartment on the back of the clock to remove the old battery.
Open the clock face and inspect the clock hands.
If the pendulum is not swinging be sure the pendulum is hung from front to back and that the clock is flush to the wall.